Penguin Chillers Cold Therapy Chiller

• 3/4HP High Efficiency Chiller
• 7,500 BTU/hr
• 65 dBA
• 110 – 120 Volts / 450 Watts / 3.9 Amps
• 17”W x 15”D x 13”H
• 49 Pounds
• Built in Pump
• 10′ power cord with GFCI protection
• Rain Proof* (*disconnect chiller and drain completely when ambient temps are freezing or below to prevent damage to chiller)
• 1 Year Product Warranty
• Proudly made in the USA

Cost to Run (lower than most expect):

At $0.12/KWh the monthly cost of operation should be around $18-$28/month.  The compressor and fan only turn on when cooling is needed, once the water reaches your set point they turn off and only the low wattage pump continues to run.

A common question we get revolves around setting the chiller up on a timer. Ideally, you’ll want to keep the water cold at all times. There are a few reasons for this –

1. Cold water keeps bacteria (slimy walls) largely under control by slowing or stopping their growth.  This significantly reduces the amount of maintenance needed to keep your water clean for longer periods of time.   This means less frequent water changes and that much lower levels of sanitizer being an effective doses (chlorine/hydrogen peroxide/etc).
2. If you are using it on a regular basis the amount of potential power savings will be fairly insignificant, the heat it would gain in the “off” period still needs to be removed when you turn it back on. So, if running is normally cost $18-$28/month you might be able to save $3-$5/month. However, you will have to change water and the filter more often, so it is unlikely to be a net cost savings.
3. When you cut power to the chiller you also cut power to the pump.  Pumps get the most wear and tear during startup, that’s when a pump is most likely to fail as well. Cycling the power to the chiller is just adding unnecessary wear and tear to the pump.

We do not recommend putting the chiller in an area that cannot get wet as the chiller, along with the tubing, will produce condensation.

In any application that requires a water chiller, strong flow is crucial. If you have some flow throughout the system, but not enough, water will freeze inside of the chiller.

Damage caused by slow flow throughout the system due to improper setup or maintenance will not be covered under the manufacturer warranty.  

*Please note your setup needs to gravity prime to the pump, the pump is not capable of self priming/suction.   Place the chiller within 3′ of the drain of your tub, the bottom of the chiller should be at the same or lower height compared to the bottom of your tub – do not elevate the chiller above the tub.  An overly long tubing run from the tub drain to the chiller inlet may cause the pump to fail to move enough water.

Cancelation Policy

Please note any orders cancelled within their lead time, prior to shipping, will be subject to a 3% cancellation fee.

Return Policy

Returns must be requested within 21 days of original shipment. All returns must be pre-approved prior to shipping your item back to us. All returned items must be in their original condition, with original packaging. A 20% stocking fee applies to all approved returns. When returning a product for a refund, you are responsible for paying all shipping costs. Original shipping costs are non-refundable. There are no refunds available on custom ordered products or chillers.

Refund Process
If upon receiving and inspecting a returned product, it is found to not be in its original condition, the return is subject to rejection. If your refund is approved, your refund will be processed and a credit will be applied to your original method of payment. All refunds may take up to 14 days to process the paperwork and issue your refund.

Check Warranty